Help with DosFlash64 in Windows 7 Ultimate 64-bit

itaintrite · 11-03-2009, 12:13 PM

Hi, I posted my question in How to 64-bit thread but figure I might get more answers/help here.

So I've followed all the instructions.
- Uninstall VIA chipset.
- Run DREB and enable test mode/load portio.sys (got file signed successfully message)

The problem is that when I run DosFlash64.exe (as admin), I get "parameter is incorrect" error right away. Any suggestion? I've tried Safe Mode. Same thing.

Thanks.

**EclipseModz** · 11-03-2009, 01:42 PM

Try redownloading it then signing it and attempt it again. May be corrupted.

itaintrite · 11-04-2009, 01:06 AM

Hi, that was the first thing I did. I got a few copies and they're all the same.

**EclipseModz** · 11-04-2009, 02:23 PM

Then i would say just boot into dos to flash your drive.

What type of drive do you have.

itaintrite · 11-05-2009, 01:06 AM

I have a Sammy ms25, already on 1.5.

**EclipseModz** · 11-05-2009, 09:25 AM

Do you have your original.bin?

11-03-2009, 12:13 PM	#1
itaintrite Novice	Help with DosFlash64 in Windows 7 Ultimate 64-bit Hi, I posted my question in How to 64-bit thread but figure I might get more answers/help here. So I've followed all the instructions. - Uninstall VIA chipset. - Run DREB and enable test mode/load portio.sys (got file signed successfully message) The problem is that when I run DosFlash64.exe (as admin), I get "parameter is incorrect" error right away. Any suggestion? I've tried Safe Mode. Same thing. Thanks.

11-03-2009, 01:42 PM	#2
EclipseModz Diet Mod	Re: Help with DosFlash64 in Windows 7 Ultimate 64-bit Try redownloading it then signing it and attempt it again. May be corrupted. Last edited by EclipseModz; 11-03-2009 at 01:43 PM.

11-04-2009, 01:06 AM	#3
itaintrite Novice	Re: Help with DosFlash64 in Windows 7 Ultimate 64-bit Hi, that was the first thing I did. I got a few copies and they're all the same.

11-04-2009, 02:23 PM	#4
EclipseModz Diet Mod	Re: Help with DosFlash64 in Windows 7 Ultimate 64-bit Then i would say just boot into dos to flash your drive. What type of drive do you have.

11-05-2009, 01:06 AM	#5
itaintrite Novice	Re: Help with DosFlash64 in Windows 7 Ultimate 64-bit I have a Sammy ms25, already on 1.5.

		Se7enSins Forums > Xbox 360 Gaming > Xbox 360 Tutorials > Firmware Hack Tutorials
Help with DosFlash64 in Windows 7 Ultimate 64-bit

11-05-2009, 09:25 AM	#6
EclipseModz Diet Mod	Re: Help with DosFlash64 in Windows 7 Ultimate 64-bit Do you have your original.bin?

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode